Power Supply FL/AL
Gives the operating or service voltage (13,8 Vdc) and the programming voltage (> 15 Vdc

Input/output modules FL/ES
Electronic mini-prints with 8 channels for INPUT/OUTPUT, some of which can be programmed as input as well as output.
- As Input channel, they can be connected to pushbuttons, switches, dry contacts.
- As Output channels, they are used control very low power features, like visualisation LEDs 

IR transmitter FL/IRE
Sends the codes of an IR remote control further to the bus, in order to transmit them to the devices connected on the bus. It is so possible to control not only the CD player, but also the electrical shutters of the windows, the lighting, the fountains in the garden.

IR receiver FL/IRR
To control any device equipped with an IR remote control (CD player, HI-FI) The commands can be sent from an ordinary remote control, but also from pushbuttons, switches, timers, etc

IR receiver FL/IRRB
IR receiver in housing. Forwards the codes of an IR remote control to the bus, in order to transmit them to the devices connected to the bus. This enables the user to control not only the CD player, but also the electrical shutters of the windows, the lighting, the fountains in the garden.

Relay module FL/R-RM-RDM-RDTM
- FL/R : functions of the TELERUPTOR type.
- FL/RM : functions of the TELERUPTOR type with manual control and visualisation led for each relay.
- FL/RDM : functions of the IHS type, with manual control and visualisation led for each relay.
- FL/RDTM : same as FL/RDM, but with TIMER function.

Dimmer control module FL/DIM
Module with 8 channels of 0-10 V. Possible Functions :
1. Set, reset, toggle, stop.
2. Dimmer-up, -down, -toggle, -preset.
3. Zone Dimmer.
4. Reading of a scenario.

With Two Channels of 300 W FL/DIMLP
Can be controlled by any system, but is ideally connected to the FL/DIM module.
Total switch-off as soon as the voltage < 350 mV.
When not working : quasi no consumption.
Very fine adjustment of the visual sensation of light.
Linearity controlled by microprocessor.
Working temperature : - 20 °C to + 40 °C

Programming module FL/RSP
For the connection of the bus and the PC with the software

"Logical Functions" module FL/LO
Electronic mini-print to be placed in embedded boxes.
With 8 canals in VERY LOW power.
Can control visualisation LEDs.
Can execute logical operations (particular functions depending on the state of other elements of the installation).

Clock module FL/CLOCK
Radio-controlled clock.

Programmed IR remote control FL/TCP
IR remote control; its "AUX" keys have been programmed with the IHS codes of the Flexicom Control System.

Interface for analog telephone Line FL/TEL
Detects the "call" and the "taking off" and transforms them into IHS commands. Example : the telephone rings: the light near the telephone is activated, the television sound level automatically decreases, etc.

FL/152
wire with connector and 2 conductors to connect switches, buttons, sockets... with FL/ES module (per 100).

FL/15B
wire with buzzer: for alarm-sound (connected to oven, doorphone...).

FL/15G
15 cm wire with connector and green LED: to connect to FL/ES module, output signal LED.

FL/15R
15 cm wire with connector and red LED: to connect to FL/ES module, output signal LED.

FL/OPTO
Optical isolation module RS 232.

FL/RV
Relay module to drive 2 motors for shutters.

Relais: 16A (30VDC - 250VAC)